FYP S2 WEEK 10

Tittle of activity :

 Step development basic burning programming

Objective :

To learn and understand better how to burn IC.

Content/procedure :

Step 1:

Launch PIC Kit 2 programming software by Selecting Start > Program > Microchip > PIC Kit 2

The following programming interface appears and notifies that the PIC Kit 2 and target device found and connected. 

Step 2: 

If device is successfully detected, the model name will appeared at “Device Configuration Area” 

Step 3 :

For UIC00A, the “VDD Target” will automatically be 5.0. User should powered +5V to the target PIC. 

Step 4 :

Go to File and select Import Hex. Browse for the Hex file location and open to start import the Hex file.

Step 5:

After Hex file has been successfully imported, the target device can be programmed by clicking on Write. The PIC will be erased and programmed with the new Hex code imported. The operation status will display on the Status Window if writing is successful. 

Step 6:

Push button is a special feature to load Hex file into the target device. Push button can be used after Programmer>Write on PIC kit Button is checked as figure below: 

Step 7:

Pressed push button and the Hex file will automatically program into the target device.

Step 8 :

The program already successful Burning Program.